[1]莫时旭,周晓冰,周迎春,等.部分充填钢箱-混凝土组合梁受力性能有限元分析[J].华侨大学学报(自然科学版),2015,36(4):455-460.[doi:10.11830/ISSN.1000-5013.2015.04.0455]
　MO Shi-xu,ZHOU Xiao-bing,ZHOU Ying-chun,et al.Finite Element Analysis of Mechanical Performance of Partially Filled Steel Box-Composite Beams[J].Journal of Huaqiao University(Natural Science),2015,36(4):455-460.[doi:10.11830/ISSN.1000-5013.2015.04.0455]
点击复制

部分充填钢箱-混凝土组合梁受力性能有限元分析()
分享到：

《华侨大学学报（自然科学版）》[ISSN:1000-5013/CN:35-1079/N]

卷:
第36卷
期数:
2015年第4期
页码:
455-460
栏目:
出版日期:
2015-07-15

文章信息/Info

Title:
Finite Element Analysis of Mechanical Performance of Partially Filled Steel Box-Composite Beams
文章编号:
1000-5013(2015)04-0455-06
作者:
莫时旭1; 2 ;  周晓冰1;  周迎春1;  张堃1
1. 广西岩土力学与工程重点实验室, 广西 桂林 541004;2. 桂林理工大学 土木与建筑工程学院, 广西 桂林 541004
Author(s):
MO Shi-xu1; 2;  ZHOU Xiao-bing1;  ZHOU Ying-chun1;  ZHANG Kun1
1. Key Laboratory of Guangxi Geotechnical and Geotechnics Engineering, Guilin 541004, China; 2. College of Civil Engineering and Arcitecture, Guilin University of Science and Technology, Guilin 541004, China
关键词:
钢箱-混凝土组合梁;  受力性能;  非线性模型;  挠度-荷载曲线
Keywords:
steel box-concrete composite beams;  mechanical performance;  nonlinear model;  deflection and load curve
分类号:
TU321.1;TU317.1
DOI:
10.11830/ISSN.1000-5013.2015.04.0455
文献标志码:
A
摘要:
为了研究部分充填钢箱-混凝土组合梁负弯矩区的受力性能,完成3根简支组合梁构件在跨中两点反向对称荷载作用下的试验.选用合适的单元类型、本构关系及破坏准则,建立以模拟试验梁为对象的非线性模型,得到相应的挠度-荷载曲线和截面应变值,模拟结果与试验结果吻合良好.通过改变梁的一些主要参数,对极限承载力和跨中挠度进行预测.分析表明:若要提高极限承载力和降低跨中挠度,可依次提高梁的配筋率,加厚底板、腹板、顶板和中隔板,也可适当提高混凝土强度.
Abstract:
The mechanical performance of partially filled steel box-concrete composite beams was investigated by the experiment of three simple-supported composite beam components under mid-span two-point antisymmetric loads. Suitable element types, constitutive relationship and failure criterion were selected to establish a nonlinear model to simulate the experimental beams. The deflection-load curves and cross-sectional strain values were obtained. The simulation results agree with the obtained experimental results, indicating the validity of finite element model. The bearing capacity and the mid-span deflection can be predicted by some of the major beam parameters. The analysis indicates that the ultimate load bearing capacity and stiffness of beams enhance as reinforcement ratio of girders, thickness of baseboard, web, roof, partition and concrete strength increase.

参考文献/References:

[1] NAKAMURAA S I,MOR ISH ITA B H.Bending strength of concrete-fill ednarrow-width steel box girder[J].Journal of Constructional Steel Research,2008,64:128-133.
[2] 张金,周志祥,向红,等.钢-混凝土组合连续梁力学性能分析[J].中外公路,2012,32(1):120-125.
[3] 解恒燕,郑文忠.内置钢箱-混凝土简支组合梁受力性能试验[J].哈尔滨工业大学学报,2009,41(2):37-42.
[4] 杨树标.按变刚度计算钢筋混凝土梁挠度[J].河北煤炭建筑工程学院学报,1992(2):1-8.
[5] 薛伟,胡夏闽,刘加荣.简支钢-混凝土组合梁挠度计算方法的探讨[J].江苏建筑,2009(125):29-31.
[6] 孙小菲,吴春生.界面滑移效应下钢-混凝土组合梁总剪力和挠度[J].南昌大学学报:工科版,2007,29(4):390-394.
[7] 刘洋,童乐为,孙波,等.负弯矩作用下钢-混凝土组合梁受力性能有限元分析及受弯承载力计算[J].建筑结构学报,2014,35(10):10-20.
[8] 周勇.钢筋混凝土梁的非线性有限元分析[J].国外建材科技,2008,29(3):22-24.
[9] 吕西林,陆伟东.反复荷载作用下方钢管混凝土柱的抗震性能试验研究[J].建筑结构学报,2000,21(2):2-11,27.
[10] 韩林海,陶忠.方钢管混凝土轴压力学性能的理论分析与试验研究[J].土木工程学报,2001,34(2):17-25.
[11] 莫时旭,郑艳,钟新谷,等.钢箱-混凝土组合梁受力性能有限元分析[J].广西大学学报:自然科学版,2010,35(4):543-548.

相似文献/References:

[1]袁彬,郭子雄.高强钢筋搭接焊缝的性能试验[J].华侨大学学报(自然科学版),2012,33(1):65.[doi:10.11830/ISSN.1000-5013.2012.01.0065]
　YUAN Bin,GUO Zi-xiong.Experimental Study on Joint Behavior of High-Strength Steel Bar Lap Weld[J].Journal of Huaqiao University(Natural Science),2012,33(4):65.[doi:10.11830/ISSN.1000-5013.2012.01.0065]
[2]张承文,淳庆.淮安板闸遗址受力性能的非线性有限元分析[J].华侨大学学报(自然科学版),2020,41(4):447.[doi:10.11830/ISSN.1000-5013.201907001]
　ZHANG Chengwen,CHUN Qing.Nonlinear Finite Element Analysis of Mechanical Performance of Huai’an Water Gate Site[J].Journal of Huaqiao University(Natural Science),2020,41(4):447.[doi:10.11830/ISSN.1000-5013.201907001]

备注/Memo

备注/Memo:
收稿日期: 2015-03-17
通信作者: 莫时旭(1964-),男,教授,博士,主要从事桥梁工程的研究.E-mail:moshixuwh@yahoo.com.cn.
基金项目: 国家自然科学基金资助项目(51168011, 51108109)
更新日期/Last Update: 2015-07-20